Non-Staining Sealant SL2000 For Porous Stone & Composite Panel - SSG

7. Available Colors

8. How to use

• CLEAN ALL JOINT SURFACE - Clean all substrate surface and regarding dust oil, frost and any contaminants Wipe polluted parts using solvent and a piece of cloth. Do not use detergent, soap and water.
• INSTALL BACK-UP MATERIALS - Backer rod materials such as closed cell polyethylene type can be used as the base of the joint to control sealant depth.
• MASK ADJACENT SURFACE WITH MASKING TAPE - Masking tape will ensure a clean, neat appearance and reduce clean up by protecting surrounding areas from excess sealant.
• PRIMING - Primer may be needed for optimum adhesion to some substrate surface.
• APPLYING SEALANT -Applying sealant deeply into joint. Sealant must be filled into the joint cavity perfectly.
• TOOL SEALANT - Tool sealant immediately after sealant application. It helps to provide smooth and flat finish and to ensure that the sealant wets the sides of the joint without any voids.
• REMOVE MASKING TAPE - Remove masking tape prior to forming sealant surface skins.
• CLEANING - Clean all stuffs around sealant cure area and do not touch when sealant is curing.

9. Limitation

SL2000 should not be applied :

• To building materials of adhesive hindrance or discoloration that bleed oil, plasticizer or solvent and so on.
• In totally confined spaces.
• When substrate surface temperatures exceed 50 ℃ and under 5 ℃.
• To wet surface (on frost-laden or damp surfaces).
• Humid day(over 85% relative humidity day).
• For continuous immersion in water or in below-grade applications.
• Surface in direct contact with food.
• For continuous high pressure and high temperature.
• Interior fire prevention section. 10) Joint region that wear is expected by physical friction.
• Region that paint is required to sealant.
• Not recommended for use on polycarbonate plastic sheeting, self-cleaning glass, non-staining fluorine coating suitability for use on other type of plastic should be tested adhesion prior to application.
• Structural glazing

10. Comparison Chart

11. Handling Precautions

• Use at room temperature in the range of 30 to 80 % relative humidity.
• Time for complete cure is depend on the thickness of sealant applied.
• Adhesion may decline in case of the substrate contaminated. For the best adhesion, clean surfaces thoroughly with solvent before applying the product.
• Wear eye protection and protective gloves when handling this product.
• Maintain adequate ventilation in the work place at all times.
• Keep in place that child’s hand does not touch and never ingest or do not touch in skin
• Keep or do work at neighborhood of heat or fire.
• Do not use besides service. / Do not inflict shock in receptacle.
• Avoid direct ray of light and keep in state that is tightly shut in place that moisture is less.
• Do not mixing with other products.
• Wash your skins cleanly after work.
• As change in quality can be at long term storage, use in validity.
• Do not use defected back-up materials. It might induce air bubble.

12. Safety and Storage

• Store in original unopened containers in a dry place. Temperature should not exceed 25 ℃ for prolonged periods. (Recommended at 5 ~ 25 ℃)
• Please, refer product MSDS for more details regarding safety information.